VR200 drain: With or without vacuum cleaner
The VR200 robot vacuum you can easily with a normal hand-held vacuum cleaner to empty. First turn the robot vacuum.
- First, you must open the cover of your suction robot. To do this, press the white release button on VR200 and fold up the cover.
- The cover defines an approximately 5 cm large hole to the dust container, and you can aspirate with any normal vacuum cleaner.
- Finally, close the cover again and can send the VR200 to the next Suction operation.
Vorwerk Kobold VR200 empty
Kobold VR200: filters and brushes clean
- Filter: Remove, as in the first paragraph described the Filter from the dust container.
- Round brush: do not Set the page with a brush, but press with two hands on the locking bar under the vacuum robot to the front. You can then remove the brush cover and the brush itself: First you lift the left side, then drag the right side of the axis. Now you can remove the dirt from the brush.
- Sensors: With a cotton swab or a soft, clean cloth you can also clean the Sensors on the side as well as on the front and bottom edges carefully.
Filters and brushes of the VR200 clean
By the way: Many more great tips for Vorkwerk Kobold VR200 can be found on our CHIP-Special-page.
The Kobold VR200 robot vacuum buy now online
